![]() Sights: Nearly all dovetail-mounted sights are drifted out toward the right, using a nylon, aluminum, or brass drift punch.ġ. When making the slave pin, its length should be slightly less than the width of the part in which it is being used, and the ends of the pin should be rounded or beveled. The slave pin must be very slightly smaller in diameter than the hole in the part, so it will push out easily as the original pin is driven in to retain the part. A slave pin is simply a short length of rod stock (in some cases, a section of a nail will do) which is used to keep two parts, or a part and a spring, together during reassembly. Slave pins: There are several references in this book to slave pins, and some non-gunsmith readers may not be familiar with the term. You may ruin a few screwdrivers but better them than the screws on a fine rifle. If you don’t have one that fits, grind or file the top until it does. Screwdrivers: Always be sure the blade of the screwdriver exactly fits the slot in the screw head, both in thickness and in width. ![]() ![]() Except for the few shop-made tools for special purposes, all of those shown here are available from one of these three sources. In the interest of preventing this sort of thing, I am including here a group of tools that are the best types for the disassembly of rifles. Countless firearms, old and new, bear the marks, burrs and gouges that are the result of using the wrong tools for taking them apart. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |